-
-
45 Dragoon reacted to Jackrabbit1957's post in the thread More reliable Remington or colt cast your vote n tell why with
Like.
I noticed that as well, it must have a bushing or was bored with a smaller hole. -
It's a good lesson for all of us: snug is sufficient, torqued is unnecessary. Just like putting grips on...over tightening the grip...
-
45 Dragoon replied to the thread More reliable Remington or colt cast your vote n tell why.I'm asking why the base pin has the much smaller diameter at the very end of it. Mike
-
45 Dragoon replied to the thread More reliable Remington or colt cast your vote n tell why.Rear base pin hole get a bushing from being wallowd out? Mike
-
The first S&W I bought was a Model 51 22 Mag. (still have it) the second one was a Model 29 4" in 1974 that left due to chemo bills in...
-
A lubed wad works as well as a blob of grease IMHO. Never had a chainfire using them. And a lot more convenient than trying to hold onto...
-
45 Dragoon replied to the thread Thick Front Sight Blades."Skinny" front sight IS the hard part. Mostly found on "race" guns, Cowboy shooters do it all the time. Mike
-
45 Dragoon reacted to .38 Special's post in the thread The most important kaboom in revolver history with Like.
Most of us probably are familiar with the story of Elmer Keith blowing up his .45 SAA, and then sending a letter about it to American...
-
45 Dragoon replied to the thread conversion cylinder by Taylors and Co.Of course I meant 6 45C rounds as all of my revolvers are conversions. Mike
-
45 Dragoon reacted to Dave DeLaurant's post in the thread conversion cylinder by Taylors and Co with Like.
Good points. Fired indoors, a Colt Dragoon would definitely get anyone's attention. My usual bedside is a 'modern' S&W M1917, which...
-
45 Dragoon replied to the thread conversion cylinder by Taylors and Co.Maybe, if the 6th shot is the all important shot . . . and it's a "bedside table" gun, the Dragoon holds six "muscular" rounds . . .
-
45 Dragoon reacted to Jackrabbit1957's post in the thread More reliable Remington or colt cast your vote n tell why with Like.
There are some mods that help cut down the fouling on the cylinder pin.
-
I make my lube from tallow, beeswax and candle wax, it's rolled into little pills and stored in a plastic container. Check out Ugly...
-
45 Dragoon replied to the thread conversion cylinder by Taylors and Co.Ron Wells Grip Frames Thanks!
-
Who made Bisley hammer for Ruger Old Army? Is it made from the scratch, or Bisley hammer spur just welded on ROA hammer?
-
-
Loading…
-
Loading…
-
Loading…